+7 (812) 4-673-673
Valcom TGD-S
The TGD-S is an immersion density meter. TGD-S is used to accurately determine the density of liquids in various tanks and tanks. The sensor is made of stainless steel and has a degree of protection IP67.
This device is easy to use. The density sensor housing is mounted on the bottom of the tank, while the electronic part is on the outside, which provides easy access to electronic parts.
The TGD-S roll also determines the density of the medium by measuring the hydrostatic pressure difference between the two membranes and gives the resulting density value.
Specifications:
This device is easy to use. The density sensor housing is mounted on the bottom of the tank, while the electronic part is on the outside, which provides easy access to electronic parts.
The TGD-S roll also determines the density of the medium by measuring the hydrostatic pressure difference between the two membranes and gives the resulting density value.
Specifications:
- Housing material - stainless steel AISI 316L
- Electrical connection + 4-20 mA 2-wire line (HART)
- Explosion protection: EEx ia IIC T5
- Degree of protection: IP67
- Operating temperature range: -40 С - +85 С
- Liquid level measurement range: 0,1 ... 30 m
Certificate:
-
RMRS
Available for order
Certificates:
Documentation:
General shipboard testing
Once the Factory Acceptance Test (FAT) has been successfully completed, the equipment should be installed on board. Upon completion of the installation, a new series of tests is carried out - the Harbor Acceptance Test (HAT).