Technical support

If you can not perform an automatic alignment of the main compass, this function will perform a manual reconciliation bearing unit and compass heading.

When the command code '21'. speed of the vessel is set to 0 The installation procedure includes a reconciliation of the relative and absolute values.

(1) setting mode for adjustment relative to the value:

(2) setting mode to calibrate the absolute value:

If executed command code '24', the display of the data shows 'AE', the display shows the rate gyro '000.0', and the mode changes to the setup mode alignment relative value.

Click on the button EXT 2 seconds, the display will show the data 'AN', and the display will show the current rate gyro compass heading mode and go into the setup mode reconciliation absolute value. (Switch setting modes is done by pressing EXT). Blink hundreds (numbers that must be entered), the display rate gyro.

To replace the number, press SHIFT, then adjust the numerical value by pressing UP (relative value: -180.0 to 180.0 degrees, the absolute value from 000.0 to 359.9 degrees).

 

If you want to enter a negative number, type the number in the most significant (hundreds), and press UP as long as the data display shows 'AE.'.

 

After entering the course, the entered numbers will flash when you press the EXT 2 seconds. If more time is 2 seconds, press ENT, the entered numbers will light steadily.

Press COMMAND, to return to the standard mode